6. Click the Start button to start simulating the tank parameters.
Note
Simulation continues for the specified period of time. It can also be stopped
manually at any time by pressing the Stop button in the Simulation window.
In the WinSetup workspace the Rosemount 2410 icon changes to the following
appearance to indicate that Simulation Mode is active:
Advanced simulation
If a Calculate Parameter check-box is selected, the simulation parameter is calculated
based on input data from the holding registers Simulation HREGS 3800 to 4056. You can
simulate one or more parameters simultaneously.
Figure 6-3: Calculation Parameter
Procedure
1. For Average Temperature, the temperature element positions must be configured:
a) Right-click the auxiliary tank device (ATD) icon in the WinSetup workspace.
b) Choose the Properties option.
c) Select the Average Temperature Calculation tab. See the Rosemount Tank
Gauging System Configuration Manual (Document No. 00809-0300-5100)
for more information.
The resulting product average temperature is available in input register
IR2100 (tank 1). It is also available in input register area starting with IR30000
(IR30044 for tank 1).
Reference Manual Service and troubleshooting
00809-0100-2410 December 2019
Rosemount 2410 Tank Hub 91
To Next Page
Loading...
