Emerson Rosemount 5300 Series - Specify Display Panel Variables

Table 6-1: LCD Parameters and Presentation on Display (continued)
Parameter Presentation on display Description
Analog output current ANOUT 4 -20 mA current
Percent range %RANGE Level value in percent of total
measurement range
Interface level IFLVL Level of the lower product
Interface distance IFDIST Distance between the upper
reference point and the
interface between the upper
and lower product
Interface level rate IFRATE The speed of interface level
movement up or down
Interface signal strength IFAMPL The signal amplitude of the
interface echo
Volume lower VOL LO Product volume of lower
product
Volume upper VOL UP Product volume of upper
product
Upper product thickness UPTKNS Thickness of the upper product
Signal quality SIG Q The signal quality
Surface/noise margin SNM The relationship between the
surface peak amplitude and the
strongest noise peak amplitude
Vapor DC VAP DC The vapor dielectric constant
6.3 Specify display panel variables
6.3.1 Specify display panel variables using Rosemount Radar
Master
Specify variables and corresponding measurement units to be presented on the display
panel (LCD) screen:
Procedure
1. Select Setup → General, or select the General icon in the Device Config window.
Reference Manual Operation
00809-0100-4530 April 2019
Reference Manual 161