F Level Transducer Block
F.1 Overview
This section contains information on the Rosemount
™
5300 Level Transducer Block (TB).
Descriptions of all Transducer Block parameters, errors, and diagnostics are listed.
Figure F-1: Transducer Block Diagram
A. Digital Signal Conversion
B. Linearization
C. Temperature Compensation
D. Damping
E. Units/Ranging
F. Diagnostics
G. Channel
Definition
The transducer block contains the actual measurement data, including a level and
distance reading. Channels 1–16 are assigned to these measurements (see Figure F-1).
The transducer block includes information about sensor type, engineering units, and all
parameters needed to configure the transmitter.
Channel definitions
Each input has an assigned channel which can be linked to the AI block. The channels for
the Rosemount
™
5300 Level Transmitter are the following:
Table F-1: Channel Assignments
Channel Name Channel Number Process variable
Level 1 CHANNEL_RADAR_LEVEL
Ullage 2 CHANNEL_RADAR_ULLAGE
Level Rate 3 CHANNEL_RADAR_LEVELRATE
Reference Manual Level Transducer Block
00809-0100-4530 April 2019
Reference Manual 425
To Next Page
Loading...
