Emerson Rosemount 5300 Series - Basic Configuration Parameters

C.2 Basic configuration parameters
This section describes basic configuration parameters for a Rosemount 5300 Level
Transmitter. Basic configuration is only needed for the Rosemount 5300 Level
Transmitters which are not pre-configured at the factory. Factory configuration is normally
specified in the Configuration Data Sheet.
C.2.1 Measurement units
Measurement units can be specified for presentation of level/interface level, level rate,
volume, and temperature values.
C.2.2 Tank and probe geometry
The basic transmitter configuration includes setting the tank geometry parameters.
Figure C-4: Tank Geometry
$
)
(
*
%
&
'
A. Upper reference point
B. Hold Off Distance/Upper Null Zone (UNZ)
C. Product level
D. Interface level
E. Zero reference point
F. Probe length
G. Tank height
Reference Manual Configuration parameters
00809-0100-4530 April 2019
Reference Manual 385