Figure 3-18: Shortening of Flexible Twin/Single Lead Probe
A. Spacer
B. Screws
C. Minimum: 1.6 in. (40 mm)
Procedure
1. Mark off the required probe length. Add at least 1.6 in. (40 mm) to the required
probe length to be inserted into the weight.
2. Loosen the screws.
3. Slide the weight upwards as much as needed in order to cut the probe.
If the weight is removed from the cables, preferably apply electrical tape to the
cables before cutting, in order to avoid the cables to unwind.
4. Cut the probe. If necessary, remove a spacer to make room for the weight.
5. Slide the weight down to the required cable length.
6. Tighten the screws.
Table 3-10: Required Torque and Hex Key Dimensions
Probe Required torque Hex key dimension
Flexible twin lead 4.4 ft-lb (6 Nm) 4 mm
Flexible single lead 4 mm wire, stainless
steel
3.7 ft-lb (5 Nm) 4 mm
4 mm wire, Alloy
C-276
1.8 ft-lb (2.5 Nm) 3 mm
4 mm wire, Alloy 400 1.8 ft-lb (2.5 Nm) 3 mm
4 mm wire, Duplex
2205
1.8 ft-lb (2.5 Nm) 3 mm
6 mm wire 7.4 ft-lb (10 Nm) 5 mm
Reference Manual Mechanical installation
00809-0100-4530 April 2019
Reference Manual 45
To Next Page
Loading...
