143
Reference Manual
00809-0100-4026, Rev HA
Section 7: Service and Troubleshooting
November 2014
Service and Troubleshooting
7.5 Logging measurement data
By using the Log Device Registers function in the RRM software, Input and Holding registers are
logged over time. It is possible to choose from different pre-defined sets of registers. This
function is useful for verifying that the transmitter is working properly.
To log device registers, choose the Tools > Log Device Registers option to open the Log Registers
window:
To begin logging:
1. Select the Browse button, select a directory to store the log file, and type a log file title.
2. Select the Select Register button and choose the register type to be logged.
3. Select the desired registers to be logged. There are three options available: Standard,
Service, and Custom. Standard and Service refer to pre-defined sets of registers. The
Custom option allows the user to choose the desired range of registers.
4. Enter the update rate. An update rate of 10 seconds means that the plot will update
every 10 seconds.
5. Select the Start Log button. The logging will proceed until the Stop Log button is
selected.
Start Log
Browse
Select Register
Update rate
To Next Page
Loading...
