Emerson Rosemount 5400 Series - Help in RRM; Installing the RRM Software for HART Communication

85
Reference Manual
00809-0100-4026, Rev HA
Section 5: Basic Configuration/Start-up
November 2014
Basic Configuration/Start-up
Software
Operating Systems supported:
 Windows XP
 Windows 7
5.4.2 Help in RRM
From the Help menu, select the Contents option to access help information. Help is also
available from a Help button in most windows.
5.4.3 Installing the RRM software for HART communication
To install the RRM:
1. Insert the installation CD into the CD-ROM drive.
2. If the installation program is not started automatically, select Run from the Windows
Start bar.
3. Enter D:\RRM\Setup.exe where D is the CD-ROM drive.
4. Follow the instructions on the screen.
5. Make sure that HART is chosen as default protocol.
6. Set COM Port Buffers to 1, see page 88.