90
Reference Manual
00809-0100-4026, Rev HA
Section 5: Basic Configuration/Start-up
November 2014
Basic Configuration/Start-up
6. Select the desired transmitter and click OK to connect.
In the RRM Status Bar, verify that RRM communicates with the transmitter:
5.4.8 Specifying measurement units
Measurement units for data presentation in RRM can be specified when the RRM program is
installed. Units can also be changed as follows:
1. From the View menu, select the Application Preferences option.
2. Select the Measurement Units tab.
3. Select the desired units for Length, Level Rate, Volume, and Temperature.
RRM communicates
with the transmitter
No communication
with the transmitter
To Next Page
Loading...
