Emerson Rosemount 5400 Series - Viewing Measurement Data; Using the Display Panel; Specifying Display Panel Variables

120
Reference Manual
00809-0100-4026, Rev HA
Section 6: Operation
November 2014
Operation
6.2 Viewing measurement data
6.2.1 Using the display panel
The Rosemount 5400 Series transmitter uses an optional display panel to present measurement
data. When the transmitter is switched on, the display panel presents information, such as
transmitter model, measurement frequency, software version, communication type (HART, FF),
serial number, HART identification tag, setting of write protection switch, and Analog Output
settings.
When the transmitter is operating, the display panel presents level, signal amplitude, volume,
and other measurement data, depending on the display panel configuration (see “Specifying
display panel variables” on page 120).
The display has two rows, with the upper row showing the measured value and the bottom row
showing the parameter name and measurement unit. The display toggles between the different
variables every 2 seconds. Variables can be selected to be presented by using a Field
Communicator, the AMS Suite, DeltaV, or the RRM software.
Figure 6-1. The Rosemount 5400 Series Display Panel
Error messages are listed in sections “LCD display error messages” on page 126 and “LED error
messages” on page 127.
6.2.2 Specifying display panel variables
It is possible to specify the variables to be presented on the display panel (LCD display).
Using a Field Communicator
For a Field Communicator, the LCD display settings are available with
HART command [2, 2, 3].
F
OUNDATION fieldbus parameters:
TRANSDUCER_1100 > LCD_PARAMETERS.
Toggling between
measurement
parameter and
measurement unit
Measurement value