Emerson Rosemount 5400 Series - Using the Simulation Mode

151
Reference Manual
00809-0100-4026, Rev HA
Section 7: Service and Troubleshooting
November 2014
Service and Troubleshooting
7.12 Using the Simulation Mode
This function can be used to simulate measurements and alarms.
RRM: choose menu option Tools > Simulation Mode:
AMS Suite: Tools > Service > Simulation Mode.
HART Command: [3, 2, 1, 3].
AMS and DeltaV
1. In the AMS/DeltaV explorer select Configure/Service Tools, choose Simulate to setup
simulation mode:
Simulate