86
Reference Manual
00809-0100-4026, Rev HA
Section 5: Basic Configuration/Start-up
November 2014
Basic Configuration/Start-up
Getting started
1. From the Start menu, select Programs > Rosemount > Rosemount Radar Master or
select the RRM icon in the Windows workspace.
2. If the Search Device window did not appear automatically, select menu option Device >
Search.
3. In the Search Device window, select communication protocol HART and select the Start
Scan button (select the Advanced button to specify start and stop address).
Now RRM searches for the transmitter.
4. The Search Device window presents a list of found transmitters.
5. Select the desired transmitter and press OK to connect. If communication does not
work, check that the correct COM port is configured correctly and is connected to the
computer. See “Specifying the COM port” on page 87. Verify from the Communication
Preferences window that HART communication is enabled.
6. The RRM Status Bar can be used to verify that RRM is communicating with the
transmitter:
RRM communicates
with the transmitter
No communication
with the transmitter
To Next Page
Loading...
