1.4.3 Mercury+ PE1 Base Board
• 168-pin Hirose FX10 module connectors (PE1-200: 2 connectors; PE1-300/400: 3 connectors)
• System controller
• Power control
• System monitor (PE1-300/400)
• Current sense (PE1-300/400)
• Low-jitter clock generator (PE1-300/400)
• Accelerometer/magnetometer/temperature sensor (PE1-300/400)
• microSD card holder
• User EEPROM
• eMMC managed NAND flash (PE1-300/400)
• PCIe ×4 interface
• USB 3.0 device connector
• USB 2.0 host connector (PE1-200: 1 connector; PE1-300/400: 4 connectors)
• Micro USB 2.0 device (UART, SPI, I2C, JTAG) connector
• 2 × RJ45 Gigabit Ethernet connectors
• mPCIe/mSATA card holder (USB only) (PE1-300/400)
• SIM card holder (optional, PE1-300/400 only)
• SMA clock and data in/out (optional, PE1-300/400 only)
• 1 × FMC LPC connector (PE1-200)
• 1 × FMC HPC connector (PE1-300)
• 2 × FMC LPC connector (PE1-400)
• 2 × 40-pin Anios pin header
• 3 × 12-pin Pmod™ pin header
• 5 to 15 V DC supply voltage
• USB bus power (with restrictions)
Please note that the available features depend on the equipped Mercury module type and on the selected
base board variant.
1.5 Xilinx Tool Support
The MPSoC devices equipped on the Mercury XU5 SoC module are supported by the Vivado HL WebPACK
Edition software, which is available free of charge. Please contact Xilinx for further information.
D-0000-445-001 9 / 64 Version 07, 25.07.2019
To Next Page
Loading...
Need help?
General
