Endress+Hauser Analytik Jena Biometra TRIO Series - Configure Beeper; Figure 51 Biometra TRIO Automatic User Logout Screen

Biometra TRIO Tools
Version 03_19 73
AUTOMATIC USER LOGOUT OFF
If the automatic user logout is switched ON the time after that the user is automatical-
ly logged out can be set. You can enter values between 30 minutes and 60 minutes.
Figure 51 Biometra TRIO automatic user logout screen
Note: The standard setting is automatic user logout OFF.
Note: The following keys are inactive in the automatic user logout screen and cannot
be used:
11.1.3 Configure Beeper
Note: The beeper can only be configured by users with the right SYSTEM CONFIGURATION
activated (see chapter "Edit user" p. 81).
ENABLE A USER TO CONFIGURE THE SYSTEM
CONFIGURATION
The Biometra TRIO Thermal Cycler has a beeper and gives an acoustic signal if a PCR
program is finished and the beeper is turned ON. The beeper can be switched ON or
OFF by activating the corresponding check box.