Endress+Hauser Gammapilot FMG50 - Table of Contents

Gammapilot FMG50 Table of contents
Endress+Hauser 5
Table of contents
1 About this document ................ 8
1.1 Document function ..................... 8
1.2 Symbols used .......................... 8
1.2.1 Safety symbols .................. 8
1.2.2 Symbols for
certain types of information and graphics 8
1.3 Documentation ........................ 9
1.3.1 Technical Information (TI) ......... 9
1.3.2 Brief Operating Instructions (KA) ..... 9
1.3.3 Safety Instructions (XA) ........... 10
1.4 Terms and abbreviations ................ 10
1.5 Registered trademarks .................. 10
2 Basic safety instructions ........... 11
2.1 Requirements for personnel .............. 11
2.2 Designated use ....................... 11
2.3 Installation, commissioning and operation ... 11
2.4 Hazardous area ....................... 12
2.5 Radiation protection ................... 12
2.5.1 Basic radiation protection guidelines . 12
2.6 Workplace safety ...................... 13
2.7 Operational safety ..................... 13
2.8 Product safety ........................ 13
2.8.1 CE mark ...................... 14
2.8.2 EAC conformity ................. 14
3 Product description ................ 15
3.1 Product design ........................ 15
3.1.1 Components of the FMG50 ........ 15
3.2 Nameplates .......................... 16
3.2.1 Device nameplate ............... 16
3.3 Scope of delivery ...................... 16
3.4 Accompanying documentation ............ 16
3.4.1 Brief Operating Instructions ....... 16
3.4.2 Description of Device Functions ..... 17
3.4.3 Safety instructions ............... 17
4 Mounting ......................... 18
4.1 Incoming acceptance, product identification,
transport, storage ..................... 18
4.1.1 Incoming acceptance ............. 18
4.1.2 Product identification ............ 18
4.1.3 Manufacturer address ............ 18
4.1.4 Transporting to the measuring point . 18
4.1.5 Storage ....................... 18
4.2 Installation conditions .................. 19
4.2.1 General information ............. 19
4.2.2 Dimensions, weights ............. 20
4.2.3 Installation conditions for level
measurement .................. 22
4.2.4 Installation conditions for point level
detection ..................... 23
4.2.5 Installation conditions for density
measurement .................. 24
4.2.6 Installation conditions for interface
measurement .................. 25
4.2.7 Installation conditions for density
profile measurement (DPS) ........ 25
4.2.8 Installation conditions for
concentration measurement ....... 26
4.2.9 Installation conditions for
concentration measurement with
radiating media ................. 27
4.2.10 Installation conditions for flow
measurement .................. 27
4.3 Post-installation check .................. 28
5 Electrical connection .............. 29
5.1 Connection compartment ................ 29
5.2 4 to 20 mA HART connection ............. 29
5.3 Terminal assignment ................... 30
5.4 Cable entries ......................... 30
5.5 Potential equalization .................. 30
5.6 Overvoltage protection (optional) .......... 31
5.7 Rated cross-section .................... 31
5.8 Fieldbus connectors .................... 31
5.8.1 Pin assignment for connector M12-
A ........................... 31
5.8.2 Connection of devices with Harting
plug Han7D .................... 32
5.9 FMG50 with RIA15 .................... 33
5.9.1 Connection of the HART device and
RIA15 without backlighting ........ 33
5.9.2 Connection of the HART device and
RIA15 with backlighting .......... 34
5.9.3 FMG50, RIA15 with installed HART
communication resistor module ..... 34
5.10 Wiring ............................. 35
5.11 Wiring examples ...................... 36
5.11.1 Point level measurement .......... 36
5.11.2 Cascade mode with 2 FMG50 units .. 36
5.11.3 Cascade mode with more than 2
FMG50 units ................... 38
5.11.4 Ex applications in conjunction with
RMA42 ....................... 39
5.11.5 SIL applications for Gammapilot in
connection with RMA42 .......... 40
5.12 Post-connection check .................. 40
6 Operation ......................... 41
6.1 Overview of the HART operating options .... 41
6.1.1 Via HART protocol ............... 41
6.1.2 Operation via FieldCare/DeviceCare .. 41
6.1.3 Operation via RIA 15 (remote
display) ....................... 41
6.1.4 Operation via WirelessHART ....... 41