Accessories Levelflex FMP51, FMP52, FMP54
100 Endress+Hauser
Accessory Description
Centering disk PEEK Æ 48 to 95 mm
(1.89 to 3.74 inch)
can be used for
•
FMP51
• FMP54
max.50(1.97)
7(0.28)
10(0.39)
Ø16(0.63)
Ø 48(1.89)
Ø 75(2.95)
Ø 95(3.74)
mm(in)
A0014576
The centering disk is suitable for probes with a rod diameter of Ø 16 mm
(0.63in) and can be used in pipes from DN40 (1½") up to DN100 (4").
Markings on the 4-leg centering disk ensure a simple tailoring. Hence the
centering disk can be adapted to the pipe diameter. See also Operating
Instructions BA377F.
•
Material of centering disk: PEEK (statically dissipative)
• Material of retaining rings: PH15-7Mo (UNS S15700)
• Admissible process temperature: –60 to +200 °C (–76 to +392 °F)
• Order code: 71069064
If the centering disk is inserted in a bypass, it must be positioned
below the lower bypass outlet. This has to be accounted for when
choosing the probe length. Generally, the centering disk should not be
mounted higher than 50 mm (1.97") from the probe end. It is
recommended not to insert the PEEK centering disk in the measuring
range of the rod probe.
The PEEK centering disk can also be ordered directly with the device
(see the Levelflex product structure, feature 610 "Accessory mounted",
option OD). In this case it is not fastened by the retaining rings.
Instead it is fixed to the end of the probe rod by a hexagonal headed
bolt (A4-70) and a Nord-Lock washer (1.4547).
To Next Page
Loading...
