Description of device parameters (operating menu) Levelflex FMP51, FMP52, FMP54
136 Endress+Hauser
Use calculated DC
Navigation
Setup ® Advanced setup ® Interface ® Autom. DC calc. ® Use calc. DC
Meaning
Confirm if the automatically calclualted DC is to be used.
Selection
• Save and exit
The calculated DC is accepted. The device quits the sequence ("End of sequence" is displayed).
•
Cancel and exit
The calculated DC is rejected; the device continues to use the old DC and quits the sequence
("End of sequence" is displayed).
• Re-input thickness
The calculated DC is rejected. The device returns to the Manual interface thickness
parameter, so that a corrected value of the manual interface thickness can be entered.
Factory setting
Cancel and exit
Additional information
The calculated DC is indicated on the display together with this parameter.
To Next Page
Loading...
