Endress+Hauser Levelflex FMP53 - Digital output 1... Digital output 4 submenus

Description of device parameters (operating menu) Levelflex FMP51, FMP52, FMP54
158 Endress+Hauser
Display options
• Good
•
Uncertain
• Bad
Out status HEX
Navigation
Setup ® Advanced setup ® Analog output 1...4 ® Out status HEX
Diagnostics ® Measured value ® Analog output 1...4 ® Out status HEX
Description
Displays the hexadecimal status of the output value of the block.
Additional information
The hexadecimal code give more detailed information on the device state than the Out status
parameter.
For the meaning of the hexadecimal code refer to BA00034S, "PROFIBUS DP/PA - Guidelines for
planning and commissioning".
"Digital output 1" ... "Digital output 4" submenu
The Digital output 1 to Digital output 4 submenus are used to configure the DO blocks of the
device.
Set point value
Navigation
Setup ® Erweitert. Setup ® Digital output 1...4 ® Set point value
Description
Enter the set point for the DO block.
Range of values
0 to 255
Factory setting
0
Set point status
Navigation
Setup ®Advanced setup ® Digital output 1...4 ® Set point status
Description
Enter the status byte for the set point of the DO block.
Range of values
0 to 255
Factory setting
0
Invert