Endress+Hauser Levelflex FMP53 - Page 167

Levelflex FMP51, FMP52, FMP54 Description of device parameters (operating menu)
Endress+Hauser 167
Description
Selection of the number format for the representation of measured values.
Selection
• Decimal
•
ft-in-1/16" (Only valid for distance units)
Factory setting
Decimal
Decimal places menu
Navigation
Setup ® Advanced setup ® Display ® Dec. places menu
Description
Number of decimal places for the representation of numbers within the operating menu.
Selection
• x
•
x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting
x.xxxx
Additional information
This parameter only determines the representation of numbers within the operating menu (e.g.
Empty calibration, Full calibration). It does not affect the measured value representation.
For measured values, the number of decimal places is defined in the Decimal places 1 to
Decimal places 4 parameters (® ä 161).