Description of device parameters (operating menu) Levelflex FMP51, FMP52, FMP54
168 Endress+Hauser
The "Configuration backup display" submenu
The Configuration backup display submenu is only visible if a display module is
connected to the device.
The configuration of the device can be saved to the display module at a certain point of time
(backup). The saved configurateion can be restored to the device if required, e.g. in order to bring
the device back into a defined state. The configuration can also be transferred to a different device
of the same type using the display module.
Configurations can only be exchanged between devices which are in the same operating
mode (see the Setup ® Operating mode parameter).
Operating time
Navigation
Setup ® Advanced setup ® Conf. backup display ® Operating time
Diagnostics ® Operating time
Description
Use this function to display the length of time the device has been in operation up to now.
Display format
Days (d), hours (h), minutes (m) and seconds (s)
Additional information
Display
The maximum number of days is 9999, which is equivalent to 27 years.
Last backup
Navigation
Setup ® Advanced setup ® Conf. backup display ® Last backup
Description
Use this function to display the time when a backup copy of the data was last saved to the display
module.
Display format
Days (d), hours (h), minutes (m) and seconds (s)
Configuration management
Navigation
Setup ® Advanced setup ® Conf. backup display ® Config. managem.
Description
Use this function to select an action to save the data to the display module. While this action is in
progress, the configuration cannot be edited via the local display and a message on the processing
status appears on the display.
To Next Page
Loading...
