Endress+Hauser Micropilot FMR60B - Status signal

Micropilot FMR60B PROFINET with Ethernet-APL Diagnostics and troubleshooting
Endress+Hauser 53
11.3.1 Diagnostic information on local display
X
1
2
A0043759
 19 Segment display without keys
1 Status symbol for event level
2 Status signal with diagnostic event
3
2
1
X X X X X X XX X
X X X X X X XX X
S
i
S801
A0043103
 20 Graphic display with keys
1 Status signal
2 Status symbol with diagnostic event and preceding symbol for event level
3 Event text
11.3.2 Diagnostic information in the operating tool
If a diagnostic event has occurred in the device, the status signal appears in the top left
status area of the operating tool together with the corresponding symbol for the event
level according to NAMUR NE 107.
Click the status signal to see the detailed status signal.
Pending diagnostic messages can also be displayed in the Active diagnostics parameter.
The diagnostic events and remedial measures can be printed out in the Diagnostic list
submenu.
11.3.3 Status signal
F
Failure (F)
A device error has occurred. The measured value is no longer valid.
C
Function check (C)
The device is in the service mode (e.g. during a simulation).
S
Out of specification (S)
Device operation:
• Outside of the technical specifications (e.g. during startup or a cleaning)
• Outside of the configuration performed by the user (e.g. sensor frequency outside the
configured span)
M
Maintenance required (M)
Maintenance required. The measured value is still valid.