Micropilot FMR60B PROFINET with Ethernet-APL Basic safety instructions
Endress+Hauser 9
Danger of burns from contact with surfaces!
‣
For elevated fluid temperatures, ensure protection against contact to prevent burns.
2.3 Workplace safety
When working on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
‣
Switch off the supply voltage before connecting the device.
2.4 Operational safety
Risk of injury!
‣
Operate the device only if it is in proper technical condition, free from errors and faults.
‣
The operator is responsible for the interference-free operation of the device.
Modifications to the device
Unauthorized modifications to the device are not permitted and can lead to unforeseeable
dangers:
‣
If modifications are nevertheless required, consult with the manufacturer.
Repair
To ensure continued operational safety and reliability:
‣
Carry out repairs on the device only if they are expressly permitted.
‣
Observe federal/national regulations pertaining to the repair of an electrical device.
‣
Use only original spare parts and accessories from the manufacturer.
Hazardous area
To eliminate danger to persons or the installation when the device is used in the
hazardous area (e.g. explosion protection, pressure vessel safety):
‣
Check the nameplate to verify whether the ordered device can be put to its intended
use in the hazardous area.
‣
Observe the specifications in the separate supplementary documentation, which is an
integral part of this manual.
2.5 Product safety
This device is designed in accordance with good engineering practice to meet state-of-the-
art safety requirements, has been tested, and left the factory in a condition in which it is
safe to operate.
It meets the general safety standards and legal requirements. It also complies with the EU
directives listed in the device-specific EU Declaration of Conformity. Endress+Hauser
confirms this by affixing the CE mark to the device.
2.6 IT security
We only provide a warranty if the device is installed and used as described in the
Operating Instructions. The device is equipped with security mechanisms to protect it
against any inadvertent changes to the device settings. IT security measures in line with
operators' security standards and designed to provide additional protection for the device
and device data transfer must be implemented by the operators themselves.
To Next Page
Loading...
Need help?
General
