Endress+Hauser Micropilot FMR60B - Operating Menu; Adapting the Diagnostic Information; List of Diagnostic Events

Micropilot FMR60B PROFINET with Ethernet-APL Diagnostics and troubleshooting
Endress+Hauser 55
2 →
S
S801 Supply voltage
Diagnostic list
Diagnostics 1
Diagnostics 2
Diagnostics 3
A0051132
‣
Select the diagnostic event and confirm
3
(ID:203)
S801 0d00h02m25s
Increase supply voltage
Supply voltage
A0051133
‣
Remedy informationClosing
11.4.2 Operating menu
In the Diagnostic list submenu, up to 5 currently pending diagnostic messages can be
displayed. If more than 5 messages are pending, the messages with the highest priority are
shown on the display.
Navigation path
Diagnostics → Diagnostic list
Queued diagnostic messages are also displayed in the Active diagnostics parameter.
Navigation: Diagnostics → Active diagnostics
11.5 Adapting the diagnostic information
The event level can be configured:
Navigation: Diagnostics → Diagnostic settings → Configuration
11.6 List of diagnostic events
If Remedy information Contact the Service Department is displayed
(www.addresses.endress.com), be ready with the service ID shown.
Diagnostic
number
Short text Remedy instructions Status
signal
[from the
factory]
Diagnostic
behavior
[from the
factory]
Diagnostic of sensor
062 Sensor connection
faulty
Check sensor connection F Alarm
151 Sensor electronic failure 1. Restart device
2. Contact service
F Alarm