Endress+Hauser Mycom CLM 152 Operating Instructions

CLS 52 sensor data
General data
Lower measuring range limit (non-compensated)
0 µS/cm ... 2000 mS/cm
Reaction time (T
90
)
< 3 seconds over total measuring range (single-circuit
instrument)
Temperature measurement
Temperature sensor Pt 100 Class A as per IEC 751
Temperature response time t
90
... < 15s
Heat transfer bushing with Pt 100
Material V4A (1.4571)
Seal O-ring, EPDM
Cell constant k (measurement deviation) ±0.5 %) 5.9 cm
-1
Storage temperature –25 ... +80 °C
Protection type (DIN 40050) IP 67
Measurement deviation (–5 ... +100 °C)
± (10 µS/cm + 0.5 % MR)
Measurement deviation (+100 ... +140 °C)
± (30 µS/cm + 0.5 % MR)
Medium temperature –5 ... +125 °C
Ambient temperature –10 ... +70 °C
for sterilisation +140 °C (max. 30 min)
Pressure max. 16 bar (90 °C)
Measuring sensor material PEEK
Surface roughness
Ra ≤ 0.5 µm
Installation
Required pipe cross-section
Dairy pipe fitting, clamp nozzle G 1½³DN 65
APV, Varivent connection
≥ DN 40
Supplementary documentation
Technical Information CLS 52 order no. 50086110
Specifications subject to change
Appendix Mycom CLM 152
80 Endress+Hauser

Endress+Hauser Mycom CLM 152 Specifications

General

Brand	Endress+Hauser
Model	Mycom CLM 152
Category	Transmitter
Language	English