Installation Proline Prowirl 73
16 Endress+Hauser
3 Installation
3.1 Incoming acceptance, transport, storage
3.1.1 Incoming acceptance
On receipt of the goods, check the following points:
• Check the packaging and the contents for damage.
• Check the shipment, make sure nothing is missing and that the scope of supply matches your
order.
3.1.2 Transport
Please note the following when unpacking or transporting to the measuring point:
• The devices must be transported in the container supplied.
• Devices with nominal diameters DN 40 to 300 (1½ to 12") may not be lifted at the transmitter
housing or at the connection housing of the remote version when transporting (å 4). Use
carrier slings when transporting and put the slings around both process connections. Avoid chains
as these could damage the housing.
#
Warning!
Risk of injury if the measuring device slips.
The center of gravity of the entire measuring device might be higher than the points around which
the slings are slung.
Therefore, when transporting, make sure that the device does not unintentionally turn or slip.
A0001871
Fig. 4: Instructions for transporting sensors with DN 40 to 300 (1½ to 12")
3.1.3 Storage
Note the following points:
• Pack the measuring device in such a way as to protect it reliably against impact for storage (and
transportation). The original packaging provides optimum protection.
• The permissible storage temperature is:
– Standard: –40 to +80 °C (–40 to +176 °F)
– ATEX II 1/2 GD version/dust ignition-proof: –20 to +55 °C (–4 to +131 °F)
• Protect the measuring device against direct sunlight during storage in order to avoid unacceptably
high surface temperatures.
To Next Page
Loading...
