Endress+Hauser Proline Prowirl 73 - Spare Parts

Troubleshooting Proline Prowirl 73
72 Endress+Hauser
9.6 Spare parts
Section 9.1 contains detailed troubleshooting instructions. The measuring device, moreover,
provides additional support in the form of continuous self-diagnosis and error messages.
Troubleshooting can entail replacing defective components with tested spare parts. The illustration
below shows the available scope of spare parts.
!
Note!
You can order spare parts directly from your Endress+Hauser service organization by providing the
serial number printed on the transmitter's nameplate (ä 13).
Spare parts are shipped as sets comprising the following parts:
• Spare part
• Additional parts, small items (screws, etc.)
• Installation instructions
• Packaging
A0001918
Fig. 30: Spare parts for transmitter Proline Prowirl 73
1 Local display module
2Board holder
3 I/O board (COM module), Non-Ex, Ex-i/IS and Ex-n version
4 Amplifier board
5 I/O board (COM module), Ex-d /XP version
6 Pre-amplifier
3
1
2
4
6
5