Endress+Hauser Proline Prowirl 73 - Accessories; Device-Specific Accessories

Proline Prowirl 73 Accessories
Endress+Hauser 59
8 Accessories
Various accessories, which can be ordered separately from Endress+Hauser, are available for the
transmitter and the sensor. Your Endress+Hauser service organization can provide detailed
information on the order codes in question.
8.1 Device-specific accessories
8.2 Measuring principle-specific accessories
Accessory Description Order code
Proline Prowirl 73
transmitter
Transmitter for replacement or for stock. Use the order
code to define the following specifications:
•Approvals
• Degree of protection / version
• Cable entries
• Display / operation
•Software
• Outputs / inputs
73XXX - XXXXX *******
Accessory Description Order code
Mounting kit for
Prowirl 73W
Mounting kit for wafer comprising:
• Threaded studs
•Nuts incl. washers
•Flange seals
DKW** - ***
Mounting kit for
transmitter
Mounting kit for remote version, suitable for pipe and
wall mounting.
DK6WM -B
Memograph M graphic
display recorder
The Memograph M graphic display recorder provides
information on all the relevant process variables.
Measured values are recorded correctly, limit values are
monitored and measuring points analyzed. The data are
stored in the 256 MB internal memory and also on a DSD
card or USB stick.
Memograph M boasts a modular design, intuitive
operation and a comprehensive security concept. The
ReadWin
®
2000 PC software is part of the standard
package and is used for configuring, visualizing and
archiving the data captured.
The mathematics channels which are optionally available
enable continuous monitoring of specific power
consumption, boiler efficiency and other parameters
which are important for efficient energy management.
RSG40 - ************
Flow conditioner To reduce the inlet run downstream of flow disturbances. DK7ST - ***
Pressure transmitter
Cerabar M
Cerabar M is used to measure the absolute and gauge
pressure of gases, steams and liquids.
The device can be used for reading the pressure into
Prowirl 73 via the burst mode. Cerabar has to be ordered
with the burst mode activated for this purpose. This is a
special product with version 9=TSPSC2821.
PMC41 - ***********
PMP41 - ***********
PM*4* - ******H/J9***
Pressure transmitter
Cerabar S
Cerabar S is used to measure the absolute and gauge
pressure of gases, steams and liquids. The device can be
used for reading the pressure into Prowirl 73 via the burst
mode. Cerabar has to be ordered with the burst mode
activated for this purpose. This is a special product with
version 9=TSPSC2822.
PMC71 - ***********
PMP71 - ***********
PM*7* - *A/B/C********9
Pressure transmitter
Cerabar T
Cerabar T is used to measure the absolute and gauge
pressure of gases, steams and liquids (compensation with
RMC621 for example).
PMC131 - ****
PMP131 - ****