Endress+Hauser Proline Prowirl 73 - Commissioning; Function Check; Switching on the Measuring Device

Proline Prowirl 73 Commissioning
Endress+Hauser 49
6 Commissioning
6.1 Function check
Make sure that all final checks have been completed before you commission your measuring point:
• Checklist for "post-installation check" ä 24
• Checklist for "post-connection check" ä 34
6.2 Switching on the measuring device
Having completed the function check, switch on the supply voltage.
After approx. 5 seconds, the device is ready for operation! The device then performs internal test
functions and the following message is shown on the local display:
The measuring device starts operating once the startup process is completed.
Various measured values and/or status variables appear on the display (HOME position).
!
Note!
If startup fails, an appropriate error message is displayed, depending on the cause. The error
messages that occur most frequently during commissioning are described in the "Troubleshooting"
section (ä 63).
PROWIRL 73
START-UP
Start-up message
Æ
DEVICE SOFTWARE
V XX.XX.XX
Display of current device software
Æ
0.0000 m3/h
0.00000 m3
Normal measuring mode commences