Endress+Hauser Proline Prowirl 73 - Communication Functions

Description of device functions Proline Prowirl 73
138 Endress+Hauser
11.13 COMMUNICATION
Function description, COMMUNICATION group
TAG NAME Description
Use this function to enter a tag name for the measuring device. You can edit and read this
tag name via the local display or the HART protocol
User input
Max. 8-character text, permitted characters are: A-Z, 0-9, +,–, punctuation marks
Factory setting
"– – – – – – – –" (no text)
TAG DESCRIPTION Description
Use this function to enter a tag description for the measuring device. You can edit and
read this tag description via the local display or the HART protocol.
User input
Max. 16-character text, permitted characters are: A-Z, 0-9, +,–, punctuation marks
Factory setting
"– – – – – – – – – – – – – – – –" (no text)
FIELDBUS ADDRESS Description
Use this function to define an address for the exchange of data with the HART protocol.
A constant 4 mA current is applied with addresses 1 to 15.
User input
0 to 15
Factory setting
0
WRITE PROTECTION Description
Use this function to check whether the measuring device can be write-accessed.
Write protection is activated and deactivated by means of DIP switches on the amplifier
board (ä 48).
Display
OFF = Write access enabled
ON = Write access disabled
Factory setting
OFF
BURST MODE Prerequisite
The BURST MODE function is only available if OFF was selected in the HART INPUT
function (ä 167).
Description
Use this function to activate cyclic data exchange of the process variables selected in the
BURST MODE CMD function (ä 139) to make communication faster.
!
Note!
If the BURST MODE function is switched on, the HART INPUT group is not active.
Options
OFF
ON
Factory setting
OFF