Endress+Hauser Proline Prowirl 73 - Page 139

Proline Prowirl 73 Description of device functions
Endress+Hauser 139
BURST MODE CMD Prerequisite
The BURST MODE CMD function is only available if OFF was selected in the BURST
MODE function (ä 138).
Description
For selecting process values that are cyclically transmitted to the HART master in the
burst mode.
Options
CMD 1
Read primary measured variable (e.g. volume flow).
CMD 2
Read current and percentage of the measuring range
CMD 3
Read current and four (previously defined) measured variables.
(see HART Command No. 51, ä 45).
Factory setting
CMD 1
MANUFACTURER ID Description
The manufacturer number in decimal numerical format appears on the display.
Display:
17 = (11 hex) for Endress+Hauser
DEVICE ID Description
The device number in hexadecimal numerical format appears on the display.
Display:
57 = (87 dec) for Prowirl 73
Function description, COMMUNICATION group