Endress+Hauser Proline Prowirl 73 - Operation; Display and Operating Elements

Proline Prowirl 73 Operation
Endress+Hauser 35
5Operation
5.1 Display and operating elements
The local display enables you to read all important parameters directly at the measuring point and
configure the device using the "Quick Setup" or the function matrix.
The display consists of two lines; this is where measured values and/or status variables (e.g. bar
graph) are displayed. You can change the assignment of the display lines to different variables to suit
your needs and preferences (ä 112, USER INTERFACE function group).
A0002011
Fig. 25: Display and operating elements
1 Liquid crystal display
Two-line display of measured values, dialog texts and fault and notice messages. The display as it appears during
standard measuring mode is known as the HOME position (operating mode).
– Top line: shows main measured values, e.g. mass flow.
– Bottom line: shows additional measured variables and status variables, e.g. totalizer reading, bar graph, tag
name.
2 Plus/minus keys
– Enter numerical values, select parameters
– Select different function groups within the function matrix
Press the P keys simultaneously to trigger the following functions:
– Exit the function matrix step by step  HOME position
– Press P keys (Esc) longer than 3 seconds  return directly to the HOME position
– Cancel data entry
3 Enter key
–HOME position  Entry into the function matrix
– Save the numerical values you input or settings you changed
Esc
E
+
-
1
32
48.25 kg/h
3702.6 tI