EasyManua.ls Logo

Endress+Hauser Proline Prowirl 73 - Page 47

Endress+Hauser Proline Prowirl 73
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Proline Prowirl 73 Operation
Endress+Hauser 47
4-7 Not assigned
5-0 310 PT breakage
5-1 311 PT short-circuit
5-2 312 PT breakage
5-3 313 PT short-circuit
5-4 314 PT breakage, electronics
5-5 315 PT short-circuit, electronics
5-6 316 No T sensor
5-7 317 The self-monitoring function of the measuring device found an error in the
DSC sensor which can affect temperature measurement.
6-0 318 The self-monitoring function of the measuring device found an error in the
DSC sensor which can affect temperature and flow measurement.
6-1 355 Frequency output: the current flow is outside the set range.
6-2 Not assigned
6-3 381 The limit value for the minimum fluid temperature permitted is undershot.
6-4 382 The limit value for the maximum fluid temperature permitted is overshot.
6-5 397 The limit value for the minimum ambient temperature permitted is undershot.
6-6 398 The limit value for the maximum ambient temperature permitted is overshot.
6-7 412 No data are available in the measuring device for the combination of the current
values for the fluid pressure and fluid temperature.
7-0 421 The current flow velocity exceeds the specified limit value.
7-1 494 The Reynolds number is lower than 20 000.
7-2 511 The current output is not receiving valid data.
7-3 512 The frequency output is not receiving valid data.
7-4 513 The pulse output is not receiving valid data.
7-5 514 The status output is not receiving valid data.
7-6 515 The display is not receiving valid data.
7-7 516 Totalizer 1 is not receiving valid data.
8-0 517 Totalizer 2 is not receiving valid data.
8-1 621 Simulation frequency output
8-2 520 The desired value has not been found in the HART telegram.
8-3 521 2 values of the same kind have been found in the HART telegram.
8-4 522 The checksum of the HART telegram is not correct.
8-5 523 The time-out for receiving HART telegrams has been exceeded.
8-6 524 An algebraic sign different from that expected has been measured for the delta
heat.
8-7 525 Wet steam alarm
9-0 526 The temperature of the saturated steam is below 80 °C (176 °F).
9-1 Not assigned
9-2 Not assigned
9-3 Not assigned
9-4 Not assigned
9-5 Not assigned
9-6 Not assigned
9-7 Not assigned
Byte Bit Error no. Short error description ä 64

Table of Contents

Other manuals for Endress+Hauser Proline Prowirl 73

Related product manuals