Endress+Hauser Promag 53 - Page 65

Promag 53 PROFIBUS-DP/-PA 5 Operation
Endress+Hauser 65
Display
The display area consists of three lines in all; this is where measured values are dis-
played, and/or status variables (direction of flow, partially filled pipe, bargraph, etc.).
You can change the assignment of display lines to variables at will in order to customize
the display to suit your needs and preferences (
→ see the “Description of Device Func-
tions” manual).
Multiplex mode:
A maximum of two different display variables can be assigned to each line.
Variables multiplexed in this way alternate every 10 seconds on the display.
Error messages:
The modes of presentation for system and process error messages are described in
detail on Page 69 ff.
Fig. 43: Typical display for normal operating mode (HOME position)
1 Main line shows primary measured values, e.g. volume flow in [l/s].
2 Supplementary line shows supplementary measured variables, e.g. totalizer No. 3 in [m
3
]
3 Information line shows additional information on the measured variables, e.g. bar graph of the limit value
reached by the volume flow.
4 “Info icons” field: Icons representing additional information on the measured values are shown in this
field. See Page 65 for a full list of the icons and their meanings.
5 “Measured values” field: The current measured values appear in this field.
6 “Unit of measure” field: The units of measure and time defined for the current measured values appear
in this field.
Icons
The icons which appear in the field on the left make it easier to read and recognise
measured variables, device status, and error messages.
Icon Meaning
S System error
P Process error

Fault message (with effect on outputs)
! Notice message (without effect on outputs)
Σ 1...n Totalizers 1...n (system totalizer)
 Note:
The totalizer amounts with the symbols
Σ 1...Σ 3 do not correspond to those that
will be sent to the automation control system (
→ see the “Description of Device
Functions” manual)
1
45
6
2
3
+24.502
+1863.97
l
m
3
s
–50
+50
%
v
3
Σ
F06-53xxxxxx-07-xx-xx-xx-001