Document number: ED.03783.00.001.ENG rev 4 Page 126 of 153
10.2 Responsibilities
Due to the regulations as stated in Ref 6 “ASME B30.1-2015” observe the following rules for
responsibilities.
The maintenance tables indicate for each maintenance jobs whether it has to be performed
either by the owner or by the manufacturer.
Contact the manufacturer for the following maintenance work:
• Adjusting the pressure in the hydraulic system.
• Adjusting and repairing hydraulic pumps and setting up hydraulic pumps.
• Adjusting and repairing control valves for all main functions.
• Adjusting the electrical system and repairs to the control system.
• Replacing parts.
In these cases the maintenance work for the owner is limited to identification of a fault.
10.3 General inspections
10.3.1 Bolts
Check if all bolts are tightened.
A torque setting list is available within appendix F.
10.3.2 Visual check of all welding
Check all welding visually on irregularities.
10.3.3 Check for irregularities
Check the System for irregularities visually.
10.3.4 Check for corrosion
Check the System for corrosion visually. Check if steel components like bolts are corroded or
damaged. Replace those parts.
10.3.5 Inspect the readability of the warning signs
Clean the warning sign if dirty. Replace the warning signs if damaged or no longer present.
The position of the warning signs are mentioned in section
To Next Page
Loading...