Document number: ED.03783.00.001.ENG rev 4 Page 22 of 153
General hazard indication
Possible precautionary measures
May cause hypersensitivity of the
airways or heritable mutations in male
reproductive cells, is a potential
carcinogen and/or is toxic to human
reproduction
Apply a strict hygiene/health policy
and wear suitable personal protection
equipment.
Explosion hazard when heated and/or
in presence of sparks
Keep away from heat, sparks, open
flames and/or hot surfaces. No
smoking!
Contains a gas under pressure. May
explode if heated
Keep out of sunlight. Store in a well-
ventilated space.
2.9 Assembly and disassembly
• Assembly and disassembly of the System has to be performed by properly trained operators
• Only use certified lifting and hoisting equipment.
Check the validity of these certificates and qualifications.
• Only use lifting and hoisting equipment with suitable capacity for the loads in question.
• Before commissioning, any parts that were disassembled for transport must be re-
assembled, re-installed, checked and approved by qualified personnel.
• Make sure that the instructions in this manual have been followed precisely before
commissioning the System.
• Lift loads as described in the user manual (connection points for lifting hooks) and observe
the professional standards.
Hazard
Any components that are blocked or stuck in any way (and any parts connected
to these components) will be under mechanical tension. If you release these
parts, they could change position suddenly and seriously injure you.
2.10 Transport, loading and unloading of the System
• Loading and unloading has to be performed by properly trained operators
• Only use lifting and hoisting equipment with suitable capacity for the loads in question.
• Lift loads as described in the user manual (connection points for lifting hooks) and observe
the professional standards.
• Only use suitable containers with adequate load-bearing capacity for transport purposes.
• Secure the load properly using suitable connection points and twist locks (for the
containers). When using twist locks secure them properly and check that the locking
mechanism is working correctly.
• Disconnect all electrical and hydraulic connections when the System has to be moved, even
if it is for only a short distance.
• To avoid damage during transport use timbers, rubber pads and plastic for packaging.
• Containers may be used for transport, since they provide rigid protection against and avoid
weather influences. Make sure that all parts are secured against sliding around.
To Next Page
Loading...