Enerpac JS125 - Symbols Applied to the System

www.enerpac.com
Document number: ED.03783.00.001.ENG rev 4 Page 17 of 153
2.3 Symbols applied to the System
The System can be labelled with
• warning symbols,
• and mandatory signs.
The table below shows the most commonly used warning symbols in industrial environments:
Danger of contact with moving machine parts
Danger
Lethal voltage in the control panels
Danger of parts of hands getting trapped/caught
Danger of parts of feet getting trapped/caught
Danger of falling
Danger
Exercise extreme attention and caution when under moving loads.
Danger of getting trapped/caught between moving parts.