Document number: ED.03783.00.001.ENG rev 4 Page 8 of 153
1.5 Liability
• Personnel as well as other people involved in the usage of the System are expected to have
read and understood this manual.
• In cases of doubt about the use or application of this machine, always contact Enerpac for
advice and recommendations.
• Unauthorised alterations to the machine may have a deleterious effect on the characteristics
of the machine and may disrupt the control functions. Unauthorised alterations therefore
annul any resultant damage claims against Enerpac.
• The risk analysis conducted by Enerpac, intended usage and reasonably foreseeable
incorrect usage of the System were assessed. The instructions in this manual were drawn
up based on this analysis.
1.6 Intended use
The definition of 'intended use' excludes any and all uses which do not meet the descriptions,
including use that exceeds the machine's technical limitations. Enerpac shall not accept any
liability for damage resulting from use that is not in accordance with the machine's intended use.
The user shall bear any and all risks. The definition of 'intended use' also includes strict
compliance with the instructions in the user manual and assumes that the equipment is
inspected and maintained at the indicated times.
• The System should only be used in the intended manner as described in the instructions in
this manual.
• The System should only be operated by operators with full knowledge of the applicable
safety regulations and the hazards which may arise during use.
• The System was developed and built according to the officially recognized safety
regulations. However, if the machine is not used as intended:
o This may pose a risk to the health and lives of operators and bystanders.
o The System may not function properly or may create hazardous situations.
• The System should only be used if the machine is in perfect technical condition.
• Faults which may result in hazardous situations must be resolved immediately.
• The machine must not be used in potentially explosive environments.
The intended use of the System is to push up a load.
Using the System on trolleys on tracks adds the intention to move the load in horizontal
direction. This is optional.
1.7 Modifications
Never make any modifications or additions which could have an adverse impact on safety
without prior approval from Enerpac. This also applies to the installation and adjustment of
safety devices and valves and welding work on the System.
Spare parts should meet the technical specifications given by Enerpac.
Apply original spare parts as these parts are made according the technical specifications of
Enerpac.
In cases of doubt, please contact Enerpac.
To Next Page
Loading...
