Document number: ED.03783.00.001.ENG rev 4 Page 9 of 153
1.8 Personnel and responsibilities
• Only qualified personnel are allowed to operate the System.
Qualified personnel are those who have certified skills to operate the System.
They should preferably have received training from Enerpac, or else from the customer.
• Only qualified personnel are allowed to maintain the System.
Qualified personnel are those who have certified main education for the jobs they have to
perform, either mechanical, hydraulical or electrical.
They should preferably have received training from Enerpac, or else from the customer.
• Qualification of the personnel is a responsibility of the customer.
• Always comply with legal minimum age stipulations.
• The System should only be used, maintained and repaired by properly instructed and
trained personnel. Clearly describe the qualifications of the relevant employees with regard
to use, commissioning, assembly, disassembly and all maintenance and repair work. If work
must be performed by third parties, they must receive clear instructions so both the client
and the contractor are up-to-date on the agreements reached.
• The supervisor and operator are authorized to refrain from following any instructions from
third parties that may pose a risk to the machines or bystanders.
• Personnel who have not been fully trained and instructed in the use of the machine, or
personnel who have only received general training, may only perform work on the System
under continuous supervision of a qualified person.
• Work on the electrical and the hydraulic systems must be performed by competent, qualified
personnel, or by trained personnel under the direct supervision of qualified personnel, in
compliance with all applicable rules and regulations.
• Assembly and disassembly may only be performed by trained installers under the
supervision of an authorized person who has adequate knowledge of the System.
The responsibilities listed the following sub-sections are in accordance with the standard as
referred to in Ref [6] ASME B30.1-2015.
In some situations, the owner and the user may be the same entity and is therefore accountable
for all of the following responsibilities listed in this chapter.In other cases, the user may lease or
rent the system without supervisory, operational, maintenance, support personnel, or services
from the system owner. In these situations, sections 1.8.1 “The owner of the system” and
1.8.2 “The user of the system” shall apply.
1.8.1 The owner of the system
The responsibilities of the owner of the system are:
a) to make sure the system meets the requirements as given in this manual as well as specific
job requirements defined by the user,
b) to make sure the system and all necessary components, specified by the manufacturer,
meet the user's requested configuration and capacity,
c) to provide the applicable capacity charts to the user,
d) to provide this manual to the user to enable correct assembly, disassembly, operation and
maintenance information,
e) to make sure all inspections and maintenance activities are performed,
f) to designate personnel for maintenance, repair, transport, assembly, and disassembly,
g) and to designate personnel for inspections as required in the applicable chapters.
To Next Page
Loading...
