Enerpac JS125 - Tension and Grease the Chain; Maintain the Travelling Distance Sensor

www.enerpac.com
Document number: ED.03783.00.001.ENG rev 4 Page 136 of 153
10.7.1 Tension and grease the chain
To tension and grease the chain of the trolley proceed as follows:
1.
Loosen the bolts
2.
Press the driving aggregate in upward
direction.
The chain is tensioned correctly when there
is 10 mm slack at its mid-point; use hand
power.
Caution: tensioning the chains
too tight might harm the
driving mechanism
3.
Fasten the bolts.
Apply torque settings according to
Appendix F “Torque settings”
4.
Grease the chain with Kroon Oil
multipurpose grease 3
10.7.2 Maintain the travelling distance sensor
1. Check whether the travelling distance sensor runs free and smoothly, and has sufficient grip on
the axis of the trolley to prevent slipping.
2. Check the spring
3. Clean the mechanism