Entrust Sigma DS3 User Manual

20 Using the Printer
When the printer is in the Ready status, the LCD displays the name of the printer.
Press the USER button to suspend the printer. Then, press ENTER to enter the menu system. Use
the arrow keys to move through the menus, and press E
NTER to make a selection. The menu
system has four major branches:
 Use the Maintenance menu to run a cleaning card, print a test card, or reset the locks on a
printer with locks.
 Use the Status menu to see settings and data about the printer.
 Use the Configuration menu to change printer settings.
 Use the Activate menu to enable or disable the printer for transport.
HINTS & TIPS
 You can access the menu system when Ready displays on line 1 of the LCD panel.
 The printer returns to the Ready status after 2 minutes of no activity. Changes that have not
been applied are lost.
 To leave a selection without changing the value, press the up or down arrow key until Exit
displays, and then press E
NTER.
The Activate menu is used only for systems that may require deactivation for
transport or reactivation following service.

Entrust Sigma DS3 Specifications

General

Print Resolution	300 dpi
Card Capacity Input Hopper	100 cards
Card Capacity Output Hopper	25 cards
Power Supply	100-240 VAC, 50/60 Hz
Print Technology	Dye sublimation
Print Capabilities	Single or dual-sided
Card Thickness	0.010 inches to 0.040 inches
Supported Card Sizes	CR80 (85.6 mm x 54 mm)
Connectivity	USB and Ethernet
Operating System Support	Windows 7, 8, 10, Server 2008, 2012, 2016
Weight	5.49 kg (12.1 lbs)
Operating Temperature	15°C to 35°C (60°F to 95°F)
Operating Humidity	20% to 80% (non-condensing)
Print Speed	Up to 250 cards per hour (YMCKT)