Entrust Sigma DS3 User Manual

40 System Maintenance
4. Cleaning Card displays on line 3 of the LCD panel. Press
E
NTER to enter the Cleaning Card menu.
5. Start displays on line 3 of the LCD panel. Press E
NTER to
start the cleaning process.
6. Insert cleaning card displays on the LCD panel. Press the
U
SER button to start the cleaning cycle.
The printer moves the card through the printer several times to clean the card track and
transport rollers.
When the cleaning cycle completes:
 If the printer does not have locks, the cleaning card is ejected into the output hopper.
Remove and discard the cleaning card.
 If the printer has locks, the cleaning card is placed in the printer reject tray.
7. Remove the used cleaning card.
8. Continue with “Prepare the Printer for Use” on page 41.
The LCD panel may display additional prompts
when cleaning a printer without locks.
When you clean a system with an attached component, the cleaning card moves
into the component to complete the cleaning cycle. Refer to the user
documentation for each component for complete information.

Entrust Sigma DS3 Specifications

General

Print Resolution	300 dpi
Card Capacity Input Hopper	100 cards
Card Capacity Output Hopper	25 cards
Power Supply	100-240 VAC, 50/60 Hz
Print Technology	Dye sublimation
Print Capabilities	Single or dual-sided
Card Thickness	0.010 inches to 0.040 inches
Supported Card Sizes	CR80 (85.6 mm x 54 mm)
Connectivity	USB and Ethernet
Operating System Support	Windows 7, 8, 10, Server 2008, 2012, 2016
Weight	5.49 kg (12.1 lbs)
Operating Temperature	15°C to 35°C (60°F to 95°F)
Operating Humidity	20% to 80% (non-condensing)
Print Speed	Up to 250 cards per hour (YMCKT)