Envision One cDLM - Page 34

Envision One cDLM® User Manual
www.envisiontec.com
TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15
Page 34 of 73
To update the Software version:
1. Tap [Update].
→ The following screen appears. It shows information about the changes in the new software versions.
2. Tap [Start].
→ The Experience Improvement message appears.
3. Tap [OK] to allow data collection or [Skip] to skip this step.
→ The process of printer updating starts.
→ The following message appears.
4. Tap [OK] to allow data collection or [Skip] to skip this step (see the Usage Analytics).
→ The process of printer updating starts.
→ After a successful printer update, the following screen appears.
5. To apply changes, reboot the printer. It will reboot automatically in 30 seconds. To reboot the printer
manually, tap [Reboot].