Epson AcuLaser C3900N - Page 142

Email
Send Email
Item Description
Send Email Send
If Enable is selected, sending Email is enabled.
Choices: Enable, Disable
Default: Enable
Configuration Menu Equivalent:
INTERFACE MENU - ETHERNET - TCP/IP - SMTP - ENABLE
SMTP Server
Address*
Specifies the address of the mail transmission server. An IPv4 or IPv6 address or a
host name can be specified.
Range: Up to 255 characters
Default: 0.0.0.0
Port Number Specifies the port number of the mail transmission server.
Range: 1 - 65535
Default: 25
Connection
Timeout
Specifies the amount of time until the connection times out when sending e-mail.
Range: 30 - 300 (seconds)
Default: 60
SMTP
Authentication
SMTP
Authentication
If Enable is selected, SMTP server authentication is enabled.
Choices: Enable, Disable
Default: Disable
Account Specify the account name used with SMTP authentication.
Range: Up to 255 characters
Password Specify the password used with SMTP authentication.
Range: Up to 128 characters
Realm Specify the realm used with Digest-MD5 authentication.
Range: Up to 255 characters
Apply button Applies the configuration settings for this window.
Clear button Resets all configuration settings to previous values.
*
Always enter these addresses without leading zeros. For example, 131.011.010.001 should be entered as 131.11.10.1.
AcuLaser C3900 Reference Guide
Using Web-Based EpsonNet Config 142