EPSON AcuLaser C1900/AcuLaser C900 Revision B
Troubleshooting Status Display (AcuLaser C1900) 132
Note *1: Jam may occur at multiple locations. In this case, they are displayed at the same
time. Also, the jam location names are separated with a space.
*2: The appropriate value among those (except Auto) for Paper Source of the Setup
menu as described in “1.4.2 List of Panel Settings (Only with AcuLaser C1900)
(p.49)” is displayed.
*3: The appropriate value among those for Paper Size of the Printing menu as described
in “1.4.2 List of Panel Settings (Only with AcuLaser C1900) (p.49)” is displayed.
*4: The appropriate value among those for paper size of the Tray menu as described in
“1.4.2 List of Panel Settings (Only with AcuLaser C1900) (p.49)” is displayed.
*5: See the description on controller-related errors in “Table 3-2. List of Service Call
Errors (Controller Related) (p.124)”.
*6: See the description on engine-related errors in “Table 3-1. List of Service Call
Errors (Engine Related) (p.124)”.
Format Error ROM A Warning 2000 p.142
Form Feed Status 1008 p.134
(Displayed during test printing) 1010
Warming Up Status 1006 p.134
Calibrating Printer Status 1014 p.134
Cooling Down Status 1016 p.134
Offline Status 1001 p.134
Cancel Print Job Status (job
cancelled by host)
1003 p.133
uuuu Toner Low Warning
(uuuu = CMYK,
only the relevant
item is displayed)
2017 ~ 2031 p.142
Worn Photoconductor Warning 2010 p.142
Waste T Box Nearfull Warning 2011 p.142
Worn Fuser Warning 2562 p.142
Worn Tranfer Unit Warning 2563 p.142
Sleep Status 1007 p.135
Ready Status 1000 p.135
(Printing) Status 1009
(Communication with inactive I/F) Status 1012
(Job being executed (printing possible)) Status 1002
Table 3-19. Messages (continued)
LED Message Category Status code Refer to
To Next Page
Loading...
