Epson AcuLaser C900 - Reverse Motor; Transfer Motor

EPSON AcuLaser C1900/AcuLaser C900 Revision B
Disassembly and Assembly Duplex Unit Disassembly and Assembly 207
4.7.3 Reverse Motor / Transfer Motor
1. Separate the Duplex Unit from the Printer.
2. Remove the Board Protection Cover.
3. Disconnect the connector (PJ1) from the Duplex Unit Control Board (PWB-A).
4. Remove the cover of the Duplex Unit (1 screw) and then remove the wires from the
code folder.
(See
“Figure 4-67 (p.207)”)
5. Remove the Reverse Motor and the Transfer Motor. (4 screws)
(See
“Figure 4-68 (p.207)”)
Figure 4-67. Cover (Duplex Cover) Removal
Figure 4-68. Reverse Motor / Transfer Motor Removal