Epson AcuLaser C900 - Network Environment (Only for Aculaser C900)

EPSON AcuLaser C1900/AcuLaser C900 Revision B
Product Description Network Environment (Only for AcuLaser C900) 81
1.7 Network Environment (Only for AcuLaser C900)
The following restrictions apply to AcuLaser C900.
 Network Environment
○ : Recommended environment
× : The print quality is not guaranteed.
(While printing is possible by sending the print data, the print results are not guaranteed.)
NOTE 1: Epson Net Direct Print is necessary for use of LPR or Port 9100 on Windows95/98/
Me.
2: For LPR or Port 9100 on Windows NT4.0/2000, Windows standard LPR or Epson Net
Direct Print can be used.
3: The default setting of NetBEUI and Netware is “ENABLE” in Leo 2.1. But AcuLaser
C900 does not support these protocols because Status Monitor can not communicate
with AcuLaser C900 via these protocols. The network setup section in AcuLaser C900
manual describes that users or administrators should set NetBEUI and Netware
protocol to DISABLE.
4: FTP, IPP and NDPS Gateway protocols can not be set to DISABLE and users can send
data to AcuLaser C900 via these protocols. But the Status Monitor can not
communicate with the printer via these protocols, so that protocols are out of
guarantee. The AcuLaser C900 users manual describes that these protocols are out of
guarantee.
 Limitations to Network Printing
Only Leo 2.1 can be used.
Leo 1.x and 2.0 can not be used. But Leo 2.0 can be updated to Leo 2.1.
 Other Information
The Network status sheet of Leo2.1 can be printed.
The Paper source selection is set to the paper source that has the paper size of the
factory default setting of the MP Tray.
Table 1-50. Applicable Network Environment
Windows 95/98/Me Windows NT4.0/2000 Mac
LPR
○○
-
Port 9100
○ ○
-
FTP
××
-
IPP
× ×
-
NetBEUI
××
-
AppleTalk - -
○
Netware
××
-
NDPS Gateway
× ×
-