Epson AcuLaser C900 - Exhaust Fan Motor (M6); Power Supply Fan Motor (M4)

EPSON AcuLaser C1900/AcuLaser C900 Revision B
Disassembly and Assembly Printer Main Parts Disassembly and Assembly 185
4.5.3 Exhaust Fan Motor (M6)
1. Remove the Upper Front Cover. (p.177)
2. Remove the Top Cover. (p.177)
3. Remove the Rear Cover. (p.178)
4. Disconnect the connector (PJ6) of the PWB-A Board and then remove the wires from
the code folder.
5. Remove the Exhaust Fan Motor. (2 screws)
4.5.4 Power Supply Fan Motor (M4)
1. Remove the Upper Front Cover. (p.177)
2. Remove the Top Cover. (p.177)
3. Open the Right Door.
4.
Remove the Rear Cover. (p.178)
5. Disconnect the connector (PJ5) from the PWB-A Board and then remove the wires
from the code folder.
6.
Remove the Upper Rear Cover. (p.178)
7. Remove the Power Supply Fan Motor. (2 screws)
(See
“Figure 4-21 (p.185)”)
Figure 4-20. Exhaust Fan Motor Removal
Figure 4-21. Power Supply Fan Motor Removal