Epson AcuLaser C900 - Error Status Details and Remedy

EPSON AcuLaser C1900/AcuLaser C900 Revision B
Troubleshooting Status Display (AcuLaser C1900) 135
SLEEP (STATUS CODE: 1007)
 Description
One of the READY messages. The printer is in a low power consumption mode.
Upon receiving printing data, the printer becomes ready for printing.
READY (STATUS CODE: 1000)
 Description
One of the READY messages. The printer is ready for printing.
3.2.4 Details of Error Status and Remedy
OPTIONAL RAM ERROR (STATUS CODE: XXXX)
 Description
The optional RAM is faulty.
 Treatment method
Turn off the power and remove the optional RAM module, and then turn on the
power.
CHECK DUPLEX P-SIZE (STATUS CODE: 4016)
 Description
Since the size of the paper fed in duplex printing is different from the paper size
preset for printing, printing stops and a paper jam occurs.
 Treatment method
Insert paper of the appropriate size, open the covers on the paper feeding routes,
remove the jammed paper, and then close the covers. The printer performs
warming up and then resumes printing from the data at which the error occurred.
CHECK MEDIA TYPE (STATUS CODE: 4226)
 Description
Since paper other than transparencies was fed in transparency printing, or a
transparency was fed in nontransparency printing, the printer canceled printing
and ejected the sheet. In duplex printing, the sheet remains in the duplex printing
unit that is causing a paper jam.
 Treatment method
1. If transparency is specified, set transparency. If transparency is not specified, set
plain paper. Pressing the Start/Stop button will let the printer recover from the
error status, and the printer will start printing.
2. If the printer does not resume printing, execute “Reset” or “Reset All” or press
the “Job Cancel” button to delete the print job data or hold it down for more than
two seconds to delete the data of all the print jobs.