EPSON AcuLaser C1900/AcuLaser C900 Revision B
Troubleshooting Status Display (AcuLaser C1900) 139
PRINT OVERRUN (STATUS CODE: 3000)
Description
During printing, if the printing data is so complicated that image processing can
not keep pace with the engine operation, the printer ejects the paper on which
printing has been performed midway and stops printing. Printing may be achieved
by retrying after setting “Page Protect = On”.
Treatment method
1. Pressing the Start/Stop button will let the printer recover from the error status.
Then if there is available memory, the printer will start printing on the page where
the error occurred and try only once to continue printing or, if possible, actually
continue printing using the whole available memory. In case there is no available
memory remaining or if the OVERRUN error has occurred again, delete the
printing data for the page where the printer failed in printing and start printing on
the subsequent pages.
2. When Auto Cont = On, the printer operates a certain time later the same way as
the case the Start/Stop button is pressed.
3. To cancel printing, execute “Reset” or “Reset All” or press the “Job Cancel”
button.
MEM OVERFLOW (STATUS CODE: 3001)
Description
If lack of memory has occurred during processing, the printer ejects the paper on
which printing has been performed midway and stops printing.
Treatment method
1. Pressing the Start/Stop button will let the printer recover from the error status. The
result of printing in this case will be in accordance with the language
specifications.
2. When Auto Cont = On, the printer operates a certain time later the same way as
the case the Start/Stop button is pressed.
3. To cancel printing, execute “Reset” or “Reset All” or press the “Job Cancel”
button.
DUPLEX MEM OVERFLOW (STATUS CODE: 3004)
Description
Since memory available for printing on the back side is insufficient, the printer
performs printing on the front side only and ejects the paper, then stops printing.
When the number of copies has been specified, the specification is invalidated.
(Warning of invalidating printing of multiple copies does not appear.)
Treatment method
1. Set the paper printed only on its front side in the paper feeder with the unprinted
side on the normal printing side and press the Start/Stop button. Then the printer
will recover from the error status and perform printing on the back side, then eject
the paper after inverting it through the Duplex Unit.
2. When Auto Cont = On, a certain time later the printer performs printing the back
side on the normal printing side of the next page and ejects the paper after
inverting it through the Duplex Unit.after inverting it through the Duplex Unit.
3. To cancel printing, execute “Reset” or “Reset All” or press the “Job Cancel”
button.
INVALID HDD (STATUS CODE: 4202)
Description
An HDD which can not be used with this printer has been installed.
Treatment method
Turn off the power and reinstall or remove the HDD. Then turn on the power
again.
INVALID PS3 (STATUS CODE: 4201)
Description
A PS3 module which can not be used with this printer has been installed.
Treatment method
Turn off the power and reinstall the PS3 module or remove the PS3 module and PS
font module. Then turn on the power again.
To Next Page
Loading...
