Epson AcuLaser C900 - Page 182

EPSON AcuLaser C1900/AcuLaser C900 Revision B
Disassembly and Assembly Cover Removal 182
9. Pull off the retaining shaft toward the right of the printer body and remove the Right
Door.
Figure 4-17. Right Door Removal 4
For installing the Right Door, follow the following procedure for easy
work.
1. Engage the long end of the torsion spring on the left side with
the hole in the frame of the Right Door.
2. Insert the retaining shaft. (Pass the shaft through the torsion
spring located on the left side.)
3. While supporting the Right Door at a slightly opened position,
near the closed position, engage the short end of the torsion
spring with the hole in the frame.
4. Install the two C-rings on the right end of the retaining shaft.