Epson Aculaser C9200N - Page 132

EPSON AcuLaser C9200N Revision D
Troubleshooting Service Call Error 132
Confidential
2
Check the connection status and stain on high voltage point between Photoconductor unit and High voltage unit.
Figure 3-1. High voltage point on Photoconductor unit
Figure 3-2. High voltage point on High voltage unit
Reset Photoconductor unit.
 Correct connection
status
 Clean high voltage
point
Go to Step 3
3
Check the installation status of PH unit. Correct installation Go to Step 4
4
Check the operation of Photoconductor unit.
Exchange
Photoconductor unit
Go to Step 5
Table 3-19. Troubleshooting
Step Remedy and Check Point Yes No